A lithium-ion battery pack with intrinsically safe LiFePO4 cells, a built-in charger, and suitable for high discharge
currents.
Nominal voltage: 12.8V
Battery capacity: 20Ah to 40Ah (not suitable for parallel or series connection)
Lightweight and easy to install
- Ideal for mobile applications.
Effective protection against improper use
- Ideal for solar power and other applications where excessive discharge might quickly cause damage to lead acid
batteries.
Output 1 :"mover": high-capacity output for caravan manoeuvring and other applications that are energyintensive
- Ideal for caravan manoeuvring (caravan movers).
- Short-circuit proof.
- Protected against excessive battery discharge.
Output 2 "domestic": for low DC loads
- Intended for lighting, audio and video, pumps, fridges.
- Short-circuit proof.
- Protected against excessive battery discharge.
Input 1 "car/solar": charging while driving or charging with a solar panel.
- Equipped with voltage and current control for safe charging of the lithium-ion battery. In fact, any source of electric
power can be connected to this input (e.g. an alternator or a battery charger), as long as 11V < Vin < 25V.
The current limit is automatically set to a safe value.
Input 2 "adapter": the adapter supplied with the Peak Power Pack can be connected to this input
- Battery charging current: 3A, and suitable for 110/230V power supply.
Rapid charging is possible via output 1 (high capacity output and 30Ah/40Ah models only)
- A battery charger or inverter/charger can be connected to the high capacity output. The maximum charging current
is 15A and 20A respectively and the recommended charging voltage is 14V (maximum 14.2V).
Storage mode
- Reduces power consumption to almost zero. Prevents damage due to excessive discharge of the battery during
storage.
Remote control with status indicator
- Push button (supplied) with a dual-colour LED status indicator:
- Short push of the button: high capacity output activated for 30 minutes (mover applications), red LED.
- Hold down for 2 seconds: high capacity output always activated, slow flashing red LED.
- Hold down for 5 seconds: storage mode, blue LED flashes 10 times.
- Battery is charged via input 1: slow flashing blue LED.
- Battery fully charged: blue LED.
- Overload or overheating: flashing red LED.
VE.Direct port: can be connected to a PC or smartphone
('VE.Direct to USB' or 'VE.Direct Bluetooth Smart dongle' required)
- Operation:
- Output 1: on / 30-minute timer / off
- Output 2: on/off
- Input 1: on/off
- Monitoring:
- Battery voltage
- Temperature and alarms