 |
 |
 |
|
Our 6 store locations may sell for less if you are able to pick up your battery.
For Dealer and volume purchase enquirers CLICK HERE.
All requests for quotation will be processed within 24hrs eastern standard time, please indicate part, quantity required and your shipping destination commercial quotations.
* Includes shipping to any Canadian provinces except Quebec and the Territories, please contact online for shipping information to those locations.
The Blue Smart IP67 Waterproof Charger is the new professional battery charger with built-in Bluetooth. The Blue Smart IP67 Waterproof Charger can be used on devices in your workshop and on motor vehicles, such as (classic) cars; motorbikes; boats and camper-vans. Models:
12V 7/13/17/25A, 24V 5/8/12A
- Bluetooth Smart enabled
The Blue Smart IP67 Charger is the wireless solution to monitor voltage and current, to change settings and to update the charger when new features become available. With Bluetooth, the functionality of the IP67 charger is enhanced and is similar to that of our IP22 and IP65 chargers.
- Completely encapsulated: waterproof, shockproof and ignition protected
Water, oil or dirt will not damage the Blue Smart IP67 Charger. The casing is made of cast aluminium and the electronics are moulded in resin.
- The highest efficiency ever!
Setting a new industry standard: with 92% efficiency or better, these chargers waste three to four times less heat. And once the battery is fully charged, power consumption reduces to less than a Watt, some five to ten times better than the industry standard.
- Adaptive 5-stage charge algorithm: bulk – absorption – recondition – float – storage
The Blue Smart Charger features a microprocessor controlled ‘adaptive’ battery management. The ‘adaptive’ feature will automatically optimise the charging process relative to the way the battery is being used.
- Storage Mode: Less maintenance and aging when the battery is not in use
The storage mode kicks in whenever the battery has not been subjected to discharge during 24 hours. In the storage mode float voltage is reduced to 2,2 V/cell (13,2 V for a 12 V battery) to minimise gassing and corrosion of the positive plates. Once a week the voltage is raised back to the absorption level to ‘equalize’ the battery. This feature prevents stratification of the electrolyte and sulphation, a major cause of early battery failure.
- Also charges Li-ion batteries
Li-ion batteries are charged with a simple bulk – absorption – float algorithm.
- Fully discharged battery recovery function
Will initiate charging even if the battery has been discharged to zero volts. Will reconnect to a fully discharged Li-ion battery with internal disconnect function.
- Protected against overheating
Can be used in a hot environment such as a machine room. Output current will reduce as temperature increases up to 60°C, but the charger will not fail.
- Two LEDs for status indication
Yellow LED: bulk charge (blinking fast), absorption (blinking slow), float (solid), storage (off) Green LED: power on
| Blue Smart IP67 Charger 120 VAC, 230 VAC |
12/7 |
12/13 |
12/17 |
12/25 |
24/5 |
24/8 |
24/12 |
| Input voltage range and frequency |
100-135 VAC 45-65 Hz 180-265 VAC 45-65 Hz |
| Efficiency |
93% |
93% |
95% |
95% |
94% |
96% |
96% |
| No load power consumption |
0.5W |
| Charge voltage 'absorption' |
Normal: 14,4V High: 14,7V Li-ion: 14,2V |
Normal: 28,8V High: 29,4V Li-ion: 28,4V |
| Charge voltage 'float' |
Normal: 13,8V High: 13,8V Li-ion: 13,5V |
Normal: 27,6V High: 27,6V Li-ion: 27,0V |
| Charge voltage ‘storage’ |
Normal: 13,2V High: 13,2V Li-ion: 13,5V |
Normal: 26,4V High: 26,4V Li-ion: 27,0V |
| Charge current, normal mode |
7A |
13A |
17A |
25A |
5A |
8A |
12A |
| Charge current, LOW |
2A |
4A |
6A |
10A |
2A |
3A |
4A |
| Charge algorithm |
5-stage adaptive |
| Can be used as power supply |
yes |
| Protection |
Battery reverse polarity (fuse) Output short circuit Over temperature |
| Operating temp. range |
30°C/-22°F to +60°C/140°F (full rated output up to 40°C/100°F) Derate 3% per °C above 40°C |
| Humidity |
Up to 100% |
| Start interrupt option (Si) |
Short circuit proof, current limit 0,5 A Output voltage: max one volt lower than main output |
| ENCLOSURE |
| Material & Colour |
aluminium (blue RAL 5012) |
| Battery-connection |
Black and red cable of 1,5 meter (5 ft) |
| 120 V AC-connection |
Cable of 1,5 meter (5 ft) with NEMA 5-15 plug |
| Protection category |
Weight (kg/lbs) |
| Weight (kg/lbs) |
1,8/4.0 |
1,8/4.0 |
2,4/5.3 |
2,4/5.3 |
1,8/4.0 |
2,4/5.3 |
2,4/5.3 |
| Dimensions (h x w x d in mm) |
85 x 211 x 60 |
85 x 211 x 60 |
99 x 219 x 65 |
99 x 219 x 65 |
85 x 211 x 60 |
99 x 219 x 65 |
99 x 219 x 65 |
| Dimensions (h x w x d in inch) |
3.4 x 8.3 x 2.4 |
3.4 x 8.3 x 2.4 |
3.9 x 8.6 x 2.6 |
3.9 x 8.6 x 2.6 |
3.4 x 8.3 x 2.4 |
3.9 x 8.6 x 2.6 |
3.9 x 8.6 x 2.6 |
| STANDARDS |
| Safety |
120VAC - UL 1236, CSA C22.2, EN 60335-1, EN 60335-2-29; 230VAC -EN 60335-1, EN 60335-2-29 |
| Emission Immunity |
EN 55014-1, EN 61000-6-3, EN 61000-3-2 |
| Automotive Directive |
EN 55014-2, EN 61000-6-1, EN 61000-6-2, EN 61000-3-3 |
|
|
|
 |
|
 |
|
